Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Square edged strips
By:Glen Longino
Date: 7/3/2003, 11:24 pm
In Response To: Re: Strip: Square edged strips (srchr/gerald)

: Ah..I know where Hico is. It's not far. Yes...I have done...and still
: do...epoxy work in this heat...and higher... sometimes over a hundred. I
: will be doing some this weekend on my hatches and coaming. I use a very
: slow epoxy, I think it is the 635/556 blushless combo, from USComposites.
: Of course, at this heat, the slow epoxy speeds up quite a bit. I just mix
: smaller amounts and go on...slowly. If I can help you in any way just let
: me know.

That's reassuring to hear. Thank you! I'm planning to build two boats at the same time. Two Great Awks, one of cypress and one of pecan. May be presumptious of me, but I will need a backup boat. I think I can build two at the same time faster than I could consecutively. We'll see! It is a fun prospect. Regards, Glen

Messages In This Thread

Strip: Square edged strips
Glen Longino -- 7/2/2003, 10:54 pm
Re: Strip: Square edged strips
Glen Longino -- 7/3/2003, 4:33 pm
Re: Strip: Square edged strips
srchr/gerald -- 7/3/2003, 5:08 pm
Re: Strip: Square edged strips
Glen Longino -- 7/3/2003, 6:18 pm
Re: Strip: Square edged strips
srchr/gerald -- 7/3/2003, 7:25 pm
Re: Strip: Square edged strips
Glen Longino -- 7/3/2003, 11:24 pm
Re: Strip: Square edged strips
rnb4tla -- 7/3/2003, 2:13 pm
Re: Strip: Square edged strips *LINK* *Pic*
John Schroeder -- 7/3/2003, 1:44 pm
Re: Strip: Square edged strips
Chip Sandresky -- 7/3/2003, 12:52 pm
Re: Strip: Square edged strips
Jay Babina -- 7/3/2003, 8:22 am
Re: Strip: Square edged strips
Andy -- 7/3/2003, 8:28 am
Re: Strip: Square edged strips
Nick Schade - Guillemot Kayaks -- 7/3/2003, 10:48 am
Thanks Jay and Nick *NM*
Andy -- 7/5/2003, 6:45 am
Re: Strip: Square edged strips
Jay Babina -- 7/3/2003, 10:37 am
I'll never go back
Kent LeBoutillier -- 7/3/2003, 6:03 am
Re: Strip: Square edged strips
srchr/gerald -- 7/3/2003, 1:52 am
Re: Strip: Square edged strips
Paul G. Jacobson -- 7/3/2003, 12:17 am
Re: Strip: Square edged strips *LINK*
Ron Deane -- 7/2/2003, 11:39 pm
Re: Strip: Square edged strips
Dave McKinney -- 7/3/2003, 4:06 pm