Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Drilling through hull
By:Don
Date: 7/11/2003, 10:56 pm
In Response To: Strip: Drilling through hull (KenC)

I used regular drill bits for drilling steel. I started out by drilling an 1/8" hole straight through. Then drilled a 1/4" hole straight through. When I drilled the 3/8" and 1/2" holes I drilled in halfway from each side.

Messages In This Thread

Strip: Drilling through hull
KenC -- 7/11/2003, 3:31 pm
Re: Strip: Drilling through hull
Mike Sundman -- 7/14/2003, 3:44 pm
Re: Strip: Drilling through hull
KenC -- 7/14/2003, 11:42 pm
Re: Strip: Drilling through hull
Scott E. Davis -- 7/14/2003, 2:00 pm
Re: Strip: Drilling through hull
Don -- 7/11/2003, 10:56 pm
Same as Don
Dave Sprygada -- 7/12/2003, 9:56 am
Re: Strip: Drilling through hull
Don Lucas -- 7/11/2003, 7:01 pm
Re: Strip: Drilling through hull
Chip Sandresky -- 7/11/2003, 5:49 pm
Re: Strip: Drilling through hull
Severne -- 7/14/2003, 11:39 am