Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Varnish sanding questions/progress pic
By:Ian in Vancouver
Date: 7/15/2003, 5:30 pm
In Response To: Re: Strip: Varnish sanding questions/progress pic (JJ Atkinson)

..... I did have a few sags in the varnish......

If you try to sand the sags off, you run the risk of over-sanding the surrounding area. I recommend a sharp cabinet scraper for the sags, then wet sand the entire surface with 220.

Boat looks good!

Messages In This Thread

Strip: Varnish sanding questions/progress pic *Pic*
JJ Atkinson -- 7/15/2003, 2:01 pm
Re: Strip: Varnish sanding questions/progress pic
Jim Owens -- 7/15/2003, 7:14 pm
Re: Strip: Varnish sanding questions/progress pic
JJ Atkinson -- 7/15/2003, 7:39 pm
Re: Strip: Varnish sanding questions/progress pic
Jim Owens -- 7/17/2003, 8:04 pm
Re: Strip: Varnish sanding questions/progress pic
Bill Price -- 7/15/2003, 4:11 pm
Re: OT - BOOKS
john -- 7/16/2003, 1:31 am
Re: OT - BOOKS
Bill Price -- 7/17/2003, 11:05 am
Re: OT - BOOKS
john -- 7/18/2003, 8:28 pm
Re: OT - BOOKS
Bill Price -- 7/16/2003, 11:47 am
Re: Strip: Varnish sanding questions/progress pic *Pic*
Kyle T -- 7/15/2003, 3:32 pm
Re: Strip: Varnish sanding questions/progress pic
JJ Atkinson -- 7/15/2003, 3:55 pm
Re: Strip: Varnish sanding questions/progress pic
Kyle T -- 7/15/2003, 4:07 pm
Re: Strip: Varnish sanding questions/progress pic
JJ Atkinson -- 7/15/2003, 4:10 pm
Re: Strip: Varnish sanding questions/progress pic
Rick Sylvia -- 7/15/2003, 2:30 pm
Re: Strip: Varnish sanding questions/progress pic
Shawn Baker -- 7/15/2003, 3:43 pm
Re: Strip: Varnish sanding questions/progress pic
JJ Atkinson -- 7/15/2003, 3:53 pm
Re: Strip: Varnish sanding questions/progress pic
Ian in Vancouver -- 7/15/2003, 5:30 pm
Re: Strip: Varnish sanding questions/progress pic
Shawn Baker -- 7/15/2003, 4:39 pm
Re: Strip: Varnish sanding questions/progress pic
Roy Morford -- 7/15/2003, 2:41 pm
Another Pic *NM* *Pic*
JJ Atkinson -- 7/15/2003, 2:02 pm