Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Uses for Mouse Pads
By:Arko Bronaugh
Date: 7/31/2003, 6:45 am
In Response To: Re: Material: Uses for Mouse Pads *LINK* *Pic* (Marcel R. in Portland, OR)

: Rick: Funny you should mention mouse pads. I was skulking about the office
: today and found some "gimme" mouse pads from vendors (semi-hard
: tops with thin neoprene on the bottom for anti-skid). I have been trying
: to come to grips with shelling out $20 for a yoga mat just to cut it to
: pieces to try that as gasket material for my hatches, so I was in a
: receptive mood. Some experimentation proved that a minimal application of
: pulling force yields a 9" x 8" sheet of 1/16" neoprene. I
: collected all that I could find and brought them home, cut them into 1
: 1/4" wide strips and glued them with contact cement around the
: underside of my rear hatch. Tomorrow, I will put a matching layer around
: the hatch lip and I will, hopefully, have a two-sided 1/8" thick
: neoprene gasket system. Total cost: $0. I like that.

: Regards,
: Marcel

: btw: The AOL CDs work well as signal mirrors, not just coasters.
Just thinkin, but wouldn't one want a single peice of material for hatch gaskets?

Messages In This Thread

Material: Uses for Mouse Pads
Rick Sylvia -- 7/30/2003, 5:12 pm
Mouse Pad Feet For Rack. *NM* *Pic*
John Monroe -- 8/2/2003, 5:24 am
Re: Material: Uses for Mouse Pads
Steve Rasmussen -- 8/1/2003, 2:15 pm
I noticed Nick thanks us for each contribution...
Robert N Pruden -- 8/1/2003, 2:15 am
Insulated Toilet Seat :) *NM*
Robert N Pruden -- 8/1/2003, 2:03 am
Re: Material: Uses for Mouse Pads
Chris Moore -- 7/31/2003, 9:01 pm
Re: Material: Uses for Mouse Pads
Ian -- 7/31/2003, 6:54 pm
AOL CD's
Dan Hughson -- 7/31/2003, 12:15 pm
Re: AOL CD's *LINK*
Alan Schwabacher -- 8/1/2003, 5:21 pm
Re: Material: Uses for Mouse Pads
bob Kelim -- 7/31/2003, 10:08 am
Re: Material: Uses for Mouse Pads
Shawn Baker -- 7/31/2003, 10:24 am
Re: Material: Uses for Mouse Pads
Marcel R. in Portland, Or. -- 7/31/2003, 11:38 am
or little ears! *NM*
Robert N Pruden -- 8/1/2003, 2:12 am
Re: Material: Uses for Mouse Pads
Shawn Baker -- 7/31/2003, 12:33 pm
Re: Material: Uses for Mouse Pads
Eric -- 7/31/2003, 5:19 pm
Free Sponsons? (shug shug) *NM*
Eric -- 7/31/2003, 5:41 pm
Re: Material: Uses for Mouse Pads
Brian Ervin -- 7/31/2003, 10:02 am
Re: Great Ideas!
Rick Sylvia -- 7/31/2003, 8:42 am
Never! ;) *NM*
Robert N Pruden -- 8/1/2003, 2:08 am
Re: Great Ideas!
JJ Atkinson -- 7/31/2003, 7:56 pm
Re: Material: Uses for Mouse Pads *LINK* *Pic*
Marcel R. in Portland, OR -- 7/31/2003, 2:47 am
Re: Material: Uses for Mouse Pads
David Hill -- 8/2/2003, 7:28 am
Re: Material: Uses for Mouse Pads
Shawn Baker -- 7/31/2003, 9:38 am
Re: Material: Uses for Mouse Pads
Arko Bronaugh -- 7/31/2003, 6:45 am
Think: "Glue" :)
Paul G. Jacobson -- 7/31/2003, 3:49 pm
Re: Think: "Glue" :)
Marcel R. in Portland, Or. -- 7/31/2003, 4:04 pm
Re: Material: Uses for Mouse Pads
Marcel R. in Portland, Or. -- 7/31/2003, 11:34 am
Re: Material: Uses for Mouse Pads
Steve Frederick -- 7/30/2003, 8:57 pm
Re: Material: Uses for Mouse Pads
Dave -- 7/30/2003, 11:17 pm
Re: Material: Uses for Mouse Pads
Shawn Baker -- 7/30/2003, 6:50 pm
Re: Material: Uses for Mouse Pads
Jim Kozel -- 7/30/2003, 8:23 pm
Re: Material: Uses for Mouse Pads
Shawn Baker -- 7/31/2003, 9:30 am
Re: Material: Uses for Mouse Pads
Rick Sylvia -- 7/31/2003, 3:19 pm
Re: Material: Uses for Mouse Pads
Glen Smith -- 7/30/2003, 8:56 pm
Re: Material: Uses for Mouse Pads
Ben Staley -- 7/30/2003, 6:12 pm
Re: Material: Uses for Mouse Pads
Danny -- 7/30/2003, 5:46 pm
Re: Material: Uses for Mouse Pads
Roger Tulk -- 7/30/2003, 11:26 pm
Re: Material: Uses for Mouse Pads
Roger Nuffer -- 7/30/2003, 5:44 pm