Andy that's a great piece of work.

I was thinking of doing that inset for the round recessed brass fittings sold by Jamestown Distributors. I was going to use those inset brass fittings as finger pulls for rare-earth held flush hatch covers. I just wasn't sure how to go about it. Smashing idea. Nice job on your page too.

(I hope this jpg shows o-kay, the one I'm looking at is round though not square)

What are your (or anyone's) thoughts on doing that for some flush hatch pulls?

Tim Eastman Grand Rapids, Mi.

: Back at the end of March when I posted photos of my hybrid Cormorant,
: Ross Leidy mailed me asking about the deck fittings. I promised him
: there would be some photos showing the method in a few days time...

: Well, it has been rather longer than that, but I finally got round to
: putting up the page ...

: Andy