Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Epoxy: Making a Kayak Mold
By:Jack Sanderson
Date: 8/19/2003, 10:25 pm
In Response To: Re: Epoxy: Making a Kayak Mold (Sam McFadden)

Sam,

The mold is CF so that the boats laid up in them can be baked in the autoclave. I suspect that a glass mold with a CF hull in it wouldn't expand at the same rates.

Jack

Messages In This Thread

Epoxy: Making a Kayak Mold *Pic*
Jack Sanderson -- 8/19/2003, 8:49 pm
Re: Epoxy: Making a Kayak Mold
Chip Sandresky -- 8/19/2003, 11:40 pm
Re: Epoxy: Making a Kayak Mold
Sam McFadden -- 8/19/2003, 10:19 pm
Re: Epoxy: Making a Kayak Mold
Jack Sanderson -- 8/19/2003, 10:25 pm
Re: Epoxy: Making a Kayak Mold *LINK*
JeffHouser -- 8/19/2003, 10:02 pm
So....
srchr/gerald -- 8/19/2003, 9:42 pm
Re: So....
Jack Sanderson -- 8/19/2003, 10:10 pm
Almost finished mold *Pic*
Jack Sanderson -- 8/19/2003, 8:59 pm
Re: Almost finished mold
Ken Sutherland -- 8/19/2003, 9:48 pm
Vacuum Bagged *Pic*
Jack Sanderson -- 8/19/2003, 8:55 pm