Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: My 2 Cents
By:Steve Frederick
Date: 9/16/2003, 7:10 pm
In Response To: Re: My 2 Cents (Ken Blanton)

Is the saw direct drive? If so, the motor could have loose bearings. That could allow the arbor/motor shaft to move, causing a wobbly cut. I think though, that you should have heard something weird or at least noticed a tell tale kerf in your table insert.
Another 2 cents.
Steve

Messages In This Thread

Strip: Strip ripping problem *Pic*
Ted G -- 9/16/2003, 2:07 pm
Re: Strip: Strip ripping problem
Rob Macks -- 9/17/2003, 5:25 pm
Update...
Ted G -- 9/17/2003, 9:03 am
make strips. not problems :)
Paul G. Jacobson -- 9/17/2003, 5:11 pm
Re: make strips. not problems :)
Ted G -- 9/17/2003, 5:24 pm
Re: Update...
Rob P -- 9/17/2003, 10:05 am
Re: Update...
Ted G -- 9/17/2003, 10:30 am
Re: Update...
Don Lucas -- 9/17/2003, 9:41 am
Re: Nice pattern though... !!
Rehd -- 9/17/2003, 12:31 am
Re: Strip: Strip ripping problem
mook -- 9/17/2003, 12:17 am
Re: Strip: Strip ripping problem
Joe Greenley -- 9/16/2003, 10:12 pm
Re: Strip: Strip ripping problem
Handy -- 9/16/2003, 9:02 pm
Re: Strip: Strip ripping problem
Dave -- 9/16/2003, 8:45 pm
Re: Strip: Strip ripping problem
Russ Chambers -- 9/16/2003, 8:30 pm
Re: Strip: Strip ripping problem
Ken Blanton -- 9/16/2003, 6:04 pm
Re: My 2 Cents
Ken Blanton -- 9/16/2003, 5:55 pm
Re: My 2 Cents
Steve Frederick -- 9/16/2003, 7:10 pm
Re: My 2 Cents
Mike Scarborough -- 9/16/2003, 6:35 pm
Re: Strip: Strip ripping problem
srchr/gerald -- 9/16/2003, 4:59 pm
Re: Strip: Strip ripping problem
Chip Sandresky -- 9/16/2003, 4:35 pm
Re: Strip: Strip ripping problem
Jay Babina -- 9/16/2003, 3:20 pm
Re: Strip: Strip ripping problem
Glen Smith -- 9/16/2003, 3:32 pm
One more thing
Jay Babina -- 9/16/2003, 3:30 pm
Re: Strip: Strip ripping problem
Rick Sylvia -- 9/16/2003, 2:37 pm
Saw info *Pic*
Ted G -- 9/16/2003, 2:47 pm
Re: Saw info
Rick Sylvia -- 9/16/2003, 3:01 pm
Re: Strip: Strip ripping problem
Jim Kozel -- 9/16/2003, 2:27 pm
Re: Strip: Strip ripping problem
Ted G -- 9/16/2003, 2:30 pm
Re: Strip: Strip ripping problem
Danny Cox -- 9/16/2003, 2:59 pm