Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Update...
By:Rob P
Date: 9/17/2003, 10:05 am
In Response To: Update... (Ted G)

For what it's worth:

I used the same blade on an old Delta 9" saw (I think it's around 1hp, too!). Extention table plus support after the saw table and support/rollers before the table. I had a feather board before the blade and I attached one to the fence and raised the saw into it. With this setup, I was able to cut 18 footers with reasonable results. I guess the point is: I don't think it's heat.

Maybe I'm strange, but I enjoyed making my own strips.

Good luck, it's worth it in the end!

Rob

Messages In This Thread

Strip: Strip ripping problem *Pic*
Ted G -- 9/16/2003, 2:07 pm
Re: Strip: Strip ripping problem
Rob Macks -- 9/17/2003, 5:25 pm
Update...
Ted G -- 9/17/2003, 9:03 am
make strips. not problems :)
Paul G. Jacobson -- 9/17/2003, 5:11 pm
Re: make strips. not problems :)
Ted G -- 9/17/2003, 5:24 pm
Re: Update...
Rob P -- 9/17/2003, 10:05 am
Re: Update...
Ted G -- 9/17/2003, 10:30 am
Re: Update...
Don Lucas -- 9/17/2003, 9:41 am
Re: Nice pattern though... !!
Rehd -- 9/17/2003, 12:31 am
Re: Strip: Strip ripping problem
mook -- 9/17/2003, 12:17 am
Re: Strip: Strip ripping problem
Joe Greenley -- 9/16/2003, 10:12 pm
Re: Strip: Strip ripping problem
Handy -- 9/16/2003, 9:02 pm
Re: Strip: Strip ripping problem
Dave -- 9/16/2003, 8:45 pm
Re: Strip: Strip ripping problem
Russ Chambers -- 9/16/2003, 8:30 pm
Re: Strip: Strip ripping problem
Ken Blanton -- 9/16/2003, 6:04 pm
Re: My 2 Cents
Ken Blanton -- 9/16/2003, 5:55 pm
Re: My 2 Cents
Steve Frederick -- 9/16/2003, 7:10 pm
Re: My 2 Cents
Mike Scarborough -- 9/16/2003, 6:35 pm
Re: Strip: Strip ripping problem
srchr/gerald -- 9/16/2003, 4:59 pm
Re: Strip: Strip ripping problem
Chip Sandresky -- 9/16/2003, 4:35 pm
Re: Strip: Strip ripping problem
Jay Babina -- 9/16/2003, 3:20 pm
Re: Strip: Strip ripping problem
Glen Smith -- 9/16/2003, 3:32 pm
One more thing
Jay Babina -- 9/16/2003, 3:30 pm
Re: Strip: Strip ripping problem
Rick Sylvia -- 9/16/2003, 2:37 pm
Saw info *Pic*
Ted G -- 9/16/2003, 2:47 pm
Re: Saw info
Rick Sylvia -- 9/16/2003, 3:01 pm
Re: Strip: Strip ripping problem
Jim Kozel -- 9/16/2003, 2:27 pm
Re: Strip: Strip ripping problem
Ted G -- 9/16/2003, 2:30 pm
Re: Strip: Strip ripping problem
Danny Cox -- 9/16/2003, 2:59 pm