Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Beginners question?
By:Randy Wright
Date: 9/26/2003, 3:00 pm
In Response To: Re: Strip: Beginners question? (Mike Scarborough)

Probably Square, if I cut my own, Bead if I buy. I can borrow a table saw, but do not have a router table.

: The most common strip with is 3/4 inches, thickness is 1/4 inches. In order
: to calculate total strips to go around the girth of the boat you should
: decide if your plan is to use square edge strips or cove and bead edged
: strips.

Messages In This Thread

Strip: Beginners question?
Randy Wright -- 9/26/2003, 10:48 am
Re: Strip: Beginners question?
David -- 9/29/2003, 5:53 pm
Re: Strip: Beginners question?
KenC -- 9/29/2003, 8:35 pm
Re: Strip: Beginners question?
David -- 9/29/2003, 10:43 pm
The Latter. *NM*
Danny Cox -- 9/29/2003, 7:24 pm
Re: Strip: Beginners question?
Jamey -- 9/27/2003, 12:15 am
Re: Strip: Beginners question?
c -- 9/26/2003, 7:54 pm
Re: Strip: Beginners question?
Mike Scarborough -- 9/26/2003, 1:34 pm
Re: Strip: Beginners question?
Randy Wright -- 9/26/2003, 3:27 pm
Re: Strip: Beginners question? *Pic*
John Monroe -- 9/27/2003, 4:22 am
Re: Strip: Beginners question?
Rob Macks -- 9/28/2003, 10:36 am
Re: Strip: Beginners question?
jesper bach -- 9/28/2003, 12:49 pm
Re: Strip: Beginners question?
Rob Macks -- 9/28/2003, 4:31 pm
Re: Strip: Beginners question?
Steve Ryan -- 9/26/2003, 4:41 pm
Re: Strip: Beginners question?
Randy Wright -- 9/26/2003, 3:00 pm
Re: Strip: Beginners question?
rnb4tla -- 9/26/2003, 4:16 pm