Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Tools: Saw for strip-cutting
By:Steve Frederick
Date: 9/26/2003, 4:44 pm
In Response To: Tools: Saw for strip-cutting (Dan G)

I'm with Chip, Get an inexpensive bench top saw. You should get good results, as you will be cutting through 1" thick material with a thin kerf blade. If you use a small 7-1/4" blade, there isn't much of a load. You could always make a set of in/out feed tables as needed.
Another 2 cents!
Steve

Messages In This Thread

Tools: Saw for strip-cutting
Dan G -- 9/26/2003, 11:42 am
Re: Tools: Saw for strip-cutting *Pic*
Andy Waddington -- 9/29/2003, 7:37 am
Re: Tools: Saw for strip-cutting
Dan G -- 9/29/2003, 11:04 am
Re: Tools: Saw for strip-cutting *Pic*
Tom Yost -- 9/27/2003, 9:56 am
Re: Tools: Saw for strip-cutting
Rob Macks -- 9/28/2003, 10:04 am
Re: Tools: Saw for strip-cutting
Paul G. Jacobson -- 9/30/2003, 12:45 am
Re: Tools: Saw for strip-cutting *LINK* *Pic*
Paul Lund -- 9/29/2003, 10:39 pm
Re: Tools: Saw for strip-cutting
Dan G -- 9/29/2003, 9:54 am
Re: Tools: Saw for strip-cutting
Rob Macks -- 9/30/2003, 11:17 am
Re: Tools: Saw for strip-cutting
Paul Probus -- 9/30/2003, 12:42 pm
Re: Tools: Saw for strip-cutting
Tom Yost -- 9/29/2003, 9:17 am
Re: Tools: Saw for strip-cutting
Rob Macks -- 9/30/2003, 11:00 am
Re: Tools: Saw for strip-cutting
Grant Glazer -- 9/29/2003, 3:19 am
Re: Tools: Saw for strip-cutting
Jay Babina -- 9/29/2003, 10:49 am
Re: Tools: Saw for strip-cutting
mike allen -- 9/29/2003, 12:56 am
Re: Tools: Saw for strip-cutting
Dave -- 9/29/2003, 11:32 am
Re: Safety
Mike Scarborough -- 9/28/2003, 10:44 am
Re: Tools: Saw for strip-cutting *Pic*
Rob Macks -- 9/28/2003, 10:10 am
Re: Tools: Saw for strip-cutting
Quentin -- 9/27/2003, 8:24 am
Re: Tools: Saw for strip-cutting
c -- 9/27/2003, 9:12 am
Re: Tools: Saw for strip-cutting *LINK*
Quentin -- 9/27/2003, 1:23 pm
Circular Saw for strip-cutting
Paul G. Jacobson -- 9/27/2003, 2:50 am
Re: Circular Saw for strip-cutting
Grant Glazer -- 9/27/2003, 2:07 pm
Re: Circular Saw for strip-cutting
Dave -- 9/27/2003, 7:32 am
Re: Tools: Saw for strip-cutting
c -- 9/26/2003, 7:42 pm
Re: Tools: Saw for strip-cutting
Steve Frederick -- 9/26/2003, 4:44 pm
Re: Tools: Saw for strip-cutting
Chip Sandresky -- 9/26/2003, 12:43 pm