Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Other: PVC Pipe Clamp Cutting - what kind of s
By:Shawn Baker
Date: 10/1/2003, 4:38 pm
In Response To: Re: Other: PVC Pipe Clamp Cutting - what kind of s (Brian Nystrom)

: Any saw with sharp teeth will to the job. PVC is easy to cut.

I busted teeth off my pull saw cutting PVC.

Go for a cheap hacksaw blade if you want to use a hand saw---or an older crosscut saw which will have softer metal than the newer harder pullsaws.

Shawn

Messages In This Thread

Other: PVC Pipe Clamp Cutting - what kind of saw?
Patsy -- 10/1/2003, 11:15 am
Table saw and mitre saw
Robert N Pruden -- 10/6/2003, 1:54 am
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Andy Waddington -- 10/1/2003, 3:17 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Patsy -- 10/1/2003, 3:25 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Severne -- 10/2/2003, 6:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Paul Jacob -- 10/3/2003, 12:00 pm
Re: Strip: Airdried or kilndried.
Peter Robinson -- 10/2/2003, 3:19 am
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Peter Robinson -- 10/2/2003, 3:24 am
width = strength
Randy Knauff -- 10/1/2003, 6:34 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Brian Nystrom -- 10/1/2003, 12:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Shawn Baker -- 10/1/2003, 4:38 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Patsy -- 10/1/2003, 1:06 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Scott Ferguson -- 10/1/2003, 1:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Brian Nystrom -- 10/2/2003, 12:37 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Chip Sandresky -- 10/1/2003, 12:38 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Brian Nystrom -- 10/2/2003, 12:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Kurt Loup, Baton Rouge -- 10/1/2003, 12:01 pm