Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Table saw and mitre saw
By:Robert N Pruden
Date: 10/6/2003, 1:54 am
In Response To: Other: PVC Pipe Clamp Cutting - what kind of saw? (Patsy)

I used my table saw to cut one side of the PVC tube, then used a mitre saw to slice the sections off. The thicker the section, the stronger the hold. I believe I made 'em about an inch wide.

Robert N Pruden

Messages In This Thread

Other: PVC Pipe Clamp Cutting - what kind of saw?
Patsy -- 10/1/2003, 11:15 am
Table saw and mitre saw
Robert N Pruden -- 10/6/2003, 1:54 am
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Andy Waddington -- 10/1/2003, 3:17 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Patsy -- 10/1/2003, 3:25 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Severne -- 10/2/2003, 6:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Paul Jacob -- 10/3/2003, 12:00 pm
Re: Strip: Airdried or kilndried.
Peter Robinson -- 10/2/2003, 3:19 am
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Peter Robinson -- 10/2/2003, 3:24 am
width = strength
Randy Knauff -- 10/1/2003, 6:34 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Brian Nystrom -- 10/1/2003, 12:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Shawn Baker -- 10/1/2003, 4:38 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Patsy -- 10/1/2003, 1:06 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Scott Ferguson -- 10/1/2003, 1:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Brian Nystrom -- 10/2/2003, 12:37 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Chip Sandresky -- 10/1/2003, 12:38 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Brian Nystrom -- 10/2/2003, 12:40 pm
Re: Other: PVC Pipe Clamp Cutting - what kind of s
Kurt Loup, Baton Rouge -- 10/1/2003, 12:01 pm