Re: upside down
By:mike allen
Date: 10/31/2003, 6:00 pm
Date: 10/31/2003, 6:00 pm
In Response To: Re: upside down (Bill Burton)
: I found it easiest to work with the boat secured at seated-shoulder height,
: but on edge. You work with your head and one arm (only) in the boat. This
: should work well with the spot-tack-then-fillet method.
: Also, I think you should tape over the fillet for strength. If you use short
: lengths of overlapping tape this is not too difficult. Trying to get long
: lengths or god forbid a continuous strip all the way around to lay flat is
: impossible.
for sure, who's to care or see? and the sitting down approach sounds pretty good, beats some of the contorted crouching i keep doing.
Messages In This Thread
- Strip: Installing bulkheads
Dave H -- 10/30/2003, 10:01 pm- upside down
Randy Knauff -- 10/31/2003, 2:51 pm- Re: upside down
mike allen -- 10/31/2003, 3:08 pm- Re: upside down
Bill Burton -- 10/31/2003, 5:24 pm- Re: upside down
mike allen -- 10/31/2003, 6:00 pm
- Re: upside down
- DITO! *NM*
Danny Cox -- 10/31/2003, 2:56 pm - Re: upside down
- Re: Strip: Installing bulkheads
mike allen -- 10/31/2003, 2:37 pm- Re: Strip: Installing bulkheads
Mike and Rikki -- 10/31/2003, 5:12 am- Re: Strip: Installing bulkheads
KenC -- 10/31/2003, 9:07 am- Re: Strip: Installing bulkheads
Mike and Rikki -- 10/31/2003, 12:52 pm
- Re: Strip: Installing bulkheads
- Re: upside down
- upside down