Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Moving from lurker to poster...
By:Geoff Horsley
Date: 11/26/2003, 8:48 pm
In Response To: Strip: Moving from lurker to poster... (Glenn Nunez)

Glenn,
I too am a newbie and considered the working height. I am 6'4" (or 191cm)and built my stands slightly higher than the book suggested. My project - Expedition Single is just about to start, just waiting for the timber to arrive. I have also just started a web site with pictures which I will try to keep updated though I may have to redo it as the pictures take a while to download. I am learning to build a kayak and a web site, should keep me out of trouble for a whille.
This is my first posting to a bulletin board so I hope it works. How do I put a picture in with the message?
The website is http://members.ozemail.com.au/~ghorsley/
and I would appreciate any comments on either the kayak building or the website.

Geoff Horsley

Messages In This Thread

Strip: Moving from lurker to poster...
Glenn Nunez -- 11/26/2003, 2:25 am
Whatever floats your boat!
Bill Cruz -- 11/29/2003, 11:23 pm
Re: Strip: Moving from lurker to poster...
Chuck -- 11/26/2003, 10:20 pm
Re: Strip: Moving from lurker to poster...
Geoff Horsley -- 11/26/2003, 8:48 pm
Excellent, Geoff
Glenn Nunez -- 11/26/2003, 8:57 pm
Re: Strip: Moving from lurker to poster...
Terry Hanson -- 11/26/2003, 1:51 pm
It's about time!!! :D
Larry -- 11/26/2003, 12:22 pm
Re: It's about time!!! :D
David Odegard -- 11/26/2003, 12:42 pm
good idea. *NM*
Larry -- 11/26/2003, 1:57 pm
Re: Strip: Moving from lurker to poster...
Gordon Snapp -- 11/26/2003, 11:23 am
Re: Strip: Moving from lurker to poster...
Greg Bridges -- 11/26/2003, 10:57 am
Working Height
Dave Sprygada -- 11/26/2003, 10:35 am
Re: ergonomics
Shawn Baker -- 11/26/2003, 10:28 am
I vote higher
Mike Scarborough -- 11/26/2003, 10:14 am
Re: Strip: Moving from lurker to poster...
Danny Cox -- 11/26/2003, 9:37 am
Re: Strip: Moving from lurker to poster...
Pete Notman -- 11/26/2003, 3:18 am