Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Making the Grab Loop Tunnels
By:Chip Sandresky
Date: 12/1/2003, 6:04 pm
In Response To: Strip: Making the Grab Loop Tunnels (Rick Sylvia)

Glad you are drying out Rick. I made those tunnels for my tandem. The trick is to start with a small hole and work your way up to larger drill bits. I used gimlets because I could hold the dowel in one hand and the gimlet in the other and eyeball the alignment with each twist. I went half way in from each side and worked my way up until I got a good pilot hole that I was sure a twist drill would follow. I guess I drilled it with ~1/4" bit on my power drill and then ~1/2". I was a little off center but I used a small pattern file to even it out.

There's probably an easier way if you have a lathe or a machine shop but this worked out fine.

www.ChipSandresky.com

Messages In This Thread

Strip: Making the Grab Loop Tunnels
Rick Sylvia -- 12/1/2003, 4:30 pm
A solution!
Rick Sylvia -- 12/2/2003, 2:56 pm
Re: A solution!
Lennie Hawkins -- 12/3/2003, 11:26 am
Re: Strip: Making the Grab Loop Tunnels *Pic*
John Monroe -- 12/2/2003, 4:18 am
Re: Strip: Making the Grab Loop Tunnels
LeeG -- 12/1/2003, 10:39 pm
Make a Fiberglass Tube Instead
Ken Blanton -- 12/1/2003, 10:31 pm
Re: I used copper pipe
Peter -- 12/2/2003, 1:01 pm
Re: I used copper pipe
Chuck -- 12/2/2003, 10:48 pm
Re: I used copper pipe *LINK*
Dave Houser -- 12/3/2003, 3:02 pm
Re: I used copper pipe
Jay Doorly -- 12/5/2003, 3:03 am
DITTO! *NM*
Danny Cox -- 12/2/2003, 8:08 am
Re: Strip: Making the Grab Loop Tunnels
Shawn Baker -- 12/1/2003, 7:06 pm
Re: Strip: Making the Grab Loop Tunnels
mike allen -- 12/1/2003, 6:36 pm
Re: Strip: Making the Grab Loop Tunnels
Chip Sandresky -- 12/1/2003, 6:04 pm
Re: Strip: Making the Grab Loop Tunnels
KenC -- 12/1/2003, 8:43 pm
Re: Strip: Making the Grab Loop Tunnels *LINK*
john -- 12/1/2003, 8:36 pm
Re: Strip: Making the Grab Loop Tunnels
c -- 12/1/2003, 5:52 pm
Re: Strip: Making the Grab Loop Tunnels
Paul Jacob -- 12/1/2003, 5:16 pm
Re: Strip: Making the Grab Loop Tunnels
Tony Bligh -- 12/1/2003, 6:02 pm
Re: Strip: Making the Grab Loop Tunnels
Ron Deane -- 12/2/2003, 8:55 am