Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Fiberglass Delamination
By:Jay Babina
Date: 3/20/2008, 8:40 am
In Response To: Epoxy: Fiberglass Delamination *Pic* (Justin L.)

My guess is that you pre-coated your wood. Blush formed and you may have cleaned it but perhaps not enough at those spots where the glass adhesion was compromised. Let me know if you pre-coated. It's my main reason I don't do that.

You'll have to take a utility knife and cut out those blisters. Sand and clean the surface and feather the edges. Lay on some glass patches a tiny bit larger than the blister overlapping on to the feathered edges. Once you sand it flush and fill the weave it should invisible. Tough break - good luck.

Messages In This Thread

Epoxy: Fiberglass Delamination *Pic*
Justin L. -- 3/19/2008, 9:12 pm
Re: Epoxy: Fiberglass Delamination
Rob Macks / Laughing Loon CC&K -- 3/20/2008, 10:10 am
Re: Epoxy: Fiberglass Delamination
Kent LeBoutillier -- 3/20/2008, 11:54 am
Re: Epoxy: Fiberglass Delamination
Roy -- 3/20/2008, 9:11 pm
Re: Epoxy: Fiberglass Delamination
Mike Savage -- 3/21/2008, 10:16 am
Re: Epoxy: Fiberglass Delamination
Roy -- 3/21/2008, 11:55 am
Re: Epoxy: Fiberglass Delamination
Rob Macks / Laughing Loon CC&K -- 3/21/2008, 3:38 pm
Re: Epoxy: Fiberglass Delamination
Etienne Muller -- 3/21/2008, 4:34 pm
Re: Epoxy: Fiberglass Delamination
Bill Hamm -- 3/20/2008, 2:51 pm
Re: Epoxy: Fiberglass Delamination
Justin L. -- 3/20/2008, 5:39 pm
Re: Epoxy: Fiberglass Delamination
Glen Smith -- 3/20/2008, 5:56 pm
Re: Epoxy: Fiberglass Delamination
Bill Hamm -- 3/20/2008, 11:42 am
Fiberglass Delamination
Jay Babina -- 3/20/2008, 8:40 am
One more thing
Jay Babina -- 3/20/2008, 11:11 am
Re: One more thing
Robert N Pruden -- 3/21/2008, 3:08 pm
Re: One more thing
Rob Macks / Laughing Loon CC&K -- 3/21/2008, 3:36 pm
Re: One more thing
Robert N Pruden -- 3/24/2008, 8:55 pm
Re: Epoxy: Fiberglass Delamination
Acors -- 3/20/2008, 8:23 am
Re: Epoxy: Fiberglass Delamination
JohnK -- 3/20/2008, 12:04 am
Re: Epoxy: Fiberglass Delamination
Toni V -- 3/20/2008, 2:54 am
Re: Epoxy: Fiberglass Delamination (Highlighted) *NM* *Pic*
Justin L. -- 3/19/2008, 9:12 pm