Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: One more thing
By:Robert N Pruden
Date: 3/24/2008, 8:55 pm
In Response To: Re: One more thing (Rob Macks / Laughing Loon CC&K)

: I'd Be very careful pulling on that glass in case some areas are stuck to the
: wood well. You could end up pulling hunks of wood out.

Yep, the glass should be pulled back only until it stops coming loose. I used this method to remove loose glass on the VJ after last springs accidently cracking-of-the-hull ceremony on the river ice. Worked well, patched up nicely.

Robert N Pruden

Messages In This Thread

Epoxy: Fiberglass Delamination *Pic*
Justin L. -- 3/19/2008, 9:12 pm
Re: Epoxy: Fiberglass Delamination
Rob Macks / Laughing Loon CC&K -- 3/20/2008, 10:10 am
Re: Epoxy: Fiberglass Delamination
Kent LeBoutillier -- 3/20/2008, 11:54 am
Re: Epoxy: Fiberglass Delamination
Roy -- 3/20/2008, 9:11 pm
Re: Epoxy: Fiberglass Delamination
Mike Savage -- 3/21/2008, 10:16 am
Re: Epoxy: Fiberglass Delamination
Roy -- 3/21/2008, 11:55 am
Re: Epoxy: Fiberglass Delamination
Rob Macks / Laughing Loon CC&K -- 3/21/2008, 3:38 pm
Re: Epoxy: Fiberglass Delamination
Etienne Muller -- 3/21/2008, 4:34 pm
Re: Epoxy: Fiberglass Delamination
Bill Hamm -- 3/20/2008, 2:51 pm
Re: Epoxy: Fiberglass Delamination
Justin L. -- 3/20/2008, 5:39 pm
Re: Epoxy: Fiberglass Delamination
Glen Smith -- 3/20/2008, 5:56 pm
Re: Epoxy: Fiberglass Delamination
Bill Hamm -- 3/20/2008, 11:42 am
Fiberglass Delamination
Jay Babina -- 3/20/2008, 8:40 am
One more thing
Jay Babina -- 3/20/2008, 11:11 am
Re: One more thing
Robert N Pruden -- 3/21/2008, 3:08 pm
Re: One more thing
Rob Macks / Laughing Loon CC&K -- 3/21/2008, 3:36 pm
Re: One more thing
Robert N Pruden -- 3/24/2008, 8:55 pm
Re: Epoxy: Fiberglass Delamination
Acors -- 3/20/2008, 8:23 am
Re: Epoxy: Fiberglass Delamination
JohnK -- 3/20/2008, 12:04 am
Re: Epoxy: Fiberglass Delamination
Toni V -- 3/20/2008, 2:54 am
Re: Epoxy: Fiberglass Delamination (Highlighted) *NM* *Pic*
Justin L. -- 3/19/2008, 9:12 pm