Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Epoxy: the dreaded runs...
By:Michael McCluskey
Date: 3/25/2008, 9:50 pm
In Response To: Epoxy: the dreaded runs... (Todd Sullivan)

I just did some fill coats. I used a squeegee to apply an extremely thin coat. There are some ridges left from the squeegee, but they are very minor. If I find any runs, I usually knock them down with a carbide scraper. Doesn't take too long and it makes sanding much faster and safer.

Good luck,

Mike

Messages In This Thread

Epoxy: the dreaded runs...
Todd Sullivan -- 3/25/2008, 9:22 pm
Re: Epoxy: the dreaded runs...
Pedro Almeida -- 3/26/2008, 8:16 pm
Re: Epoxy: taping seams and rollers *LINK*
Rod Tait -- 3/26/2008, 10:38 am
Re: Epoxy: the dreaded runs...
Etienne Muller -- 3/26/2008, 6:58 am
Re: Epoxy: the dreaded runs...
Todd Sullivan -- 3/26/2008, 8:41 am
Stop now. You're done.
Paul G. Jacobson -- 3/27/2008, 6:48 pm
Re: Stop now. You're done.
Acors -- 3/28/2008, 5:17 pm
Re: Stop now. You're done.
Todd Sullivan -- 3/28/2008, 10:15 am
Re: Epoxy: the dreaded runs...
Glen Smith -- 3/26/2008, 10:08 am
Re: Epoxy: the dreaded runs...
Jesper B -- 3/26/2008, 5:16 am
Re: Epoxy: the dreaded runs...
Greg Clopton -- 3/26/2008, 12:29 am
Re: Epoxy: the dreaded runs...
Pedro Almeida -- 3/26/2008, 8:35 pm
Re: Epoxy: the dreaded runs...
Bill Hamm -- 3/27/2008, 7:18 am
Re: Epoxy: the dreaded runs...
Michael McCluskey -- 3/25/2008, 9:50 pm