Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: varnishing
By:Bryan Hansel
Date: 4/3/2008, 8:50 am
In Response To: Material: varnishing (gilles moreau)

: is 75 degrees. have I missed anything to get that perfect finish?
: Is this only possible if one sprays it on?

There are degrees of perfection. Sand, brush, repeat. If you're getting too many bubbles, think about your brushing. Are you introducing bubbles via the brush?

Messages In This Thread

Material: varnishing
gilles moreau -- 4/2/2008, 8:14 pm
Re: Material: varnishing
Bill Hamm -- 4/3/2008, 3:23 pm
Re: Material: varnishing
Bryan Hansel -- 4/3/2008, 8:50 am
Re: Material: varnishing
Bill Hamm -- 4/3/2008, 12:39 am
Re: Material: varnishing
Glen Smith -- 4/3/2008, 9:00 am
Re: Material: varnishing
Bill Hamm -- 4/3/2008, 3:18 pm
Re: Material: varnishing
Todd Sullivan -- 4/3/2008, 3:39 pm
Re: Material: varnishing
Bill Hamm -- 4/4/2008, 10:52 am
Re: Material: varnishing
Todd Sullivan -- 4/4/2008, 11:39 am
Re: Material: varnishing
Bill Hamm -- 4/4/2008, 4:04 pm
Re: Material: varnishing
Glen Smith -- 4/2/2008, 8:41 pm