Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: building with strips
By:Duane Strosaker
Date: 4/16/2008, 7:39 pm
In Response To: S&G: building with strips (Marie)

I think you could make the side and deck panels for a Point Bennett from strips laid flat (as Lei Chang did), but there is too much twist in the bottom panels near the ends to make them out of anything but 4mm ply.

Messages In This Thread

S&G: building with strips
Marie -- 4/15/2008, 11:48 am
Re: S&G: building with strips
Paul G. Jacobson -- 4/24/2008, 9:04 pm
Re: S&G: building with strips
Duane Strosaker -- 4/16/2008, 7:39 pm
Re: S&G: building with strips *LINK*
Don Goss -- 4/16/2008, 8:44 am
Re: S&G: building with strips
Bill Hamm -- 4/17/2008, 12:33 am
Re: S&G: building with strips
Bill Hamm -- 4/16/2008, 1:44 am
Re: S&G: building with strips
Donovan -- 4/15/2008, 10:45 pm
Re: S&G: building with strips
HenkA -- 4/15/2008, 8:38 pm
Re: S&G: building with strips
Bill Hamm -- 4/16/2008, 1:40 am
Re: S&G: building with strips
HenkA -- 4/16/2008, 12:40 pm
Re: S&G: building with strips
Bill Hamm -- 4/17/2008, 12:30 am
Re: S&G: building with strips
HenkA -- 4/18/2008, 3:28 am
Re: S&G: building with strips
Bill Hamm -- 4/17/2008, 12:27 am
Re: S&G: building with strips------WebKitFormBound
Dan Caouette (CSFW)------WebKitFormBoundarygNJyoo+ -- 4/16/2008, 2:51 pm
Re: S&G: building with strips------WebKitFormBound
HenkA -- 4/16/2008, 4:07 pm
Re: S&G: building with strips
Mike Savage -- 4/15/2008, 9:40 pm
Re: S&G: building with strips
HenkA -- 4/16/2008, 1:01 pm
Re: S&G: building with strips
Mike Savage -- 4/16/2008, 6:37 pm
Re: S&G: building with strips
Brad Shook -- 4/15/2008, 3:11 pm
Re: S&G: building with strips
Mike Savage -- 4/15/2008, 2:42 pm