Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: More coaming questions.
By:Kudzu
Date: 6/6/2008, 9:02 am
In Response To: Re: Strip: More coaming questions. *Pic* (Etienne Muller)

For some reason I was thinking that the coaming should be flat. That is the top of the coaming should be on the same plane. I would rather ask an obvious/dumb question before messing up. I will just mark and trim this one down then.

Just to make sure, the lip needs to be 1/2" wide or wider?

Messages In This Thread

Strip: More coaming questions. *Pic*
Kudzu -- 6/5/2008, 9:34 pm
OK, I trimmed it down *Pic*
Kudzu -- 6/6/2008, 11:10 pm
Re: Strip: More coaming questions.
Jay Babina -- 6/6/2008, 9:20 am
Re: Strip: More coaming questions.
Etienne Muller -- 6/6/2008, 9:42 am
Re: Strip: More coaming questions.
Kudzu -- 6/6/2008, 9:59 am
16" wide is correct *NM*
Jay Babina -- 6/6/2008, 2:21 pm
Re: Strip: More coaming questions. *Pic*
Etienne Muller -- 6/6/2008, 11:04 am
Re: Strip: More coaming questions. *Pic*
Etienne Muller -- 6/6/2008, 8:11 am
Re: Strip: More coaming questions.
Kudzu -- 6/6/2008, 9:02 am
Re: Strip: More coaming questions. *Pic*
Etienne Muller -- 6/6/2008, 9:21 am
Re: Strip: More coaming questions.
JohnK -- 6/5/2008, 11:40 pm