Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Forms on the Strongback
By:Len Thunberg
Date: 6/21/2008, 4:16 pm
In Response To: Re: Strip: Forms on the Strongback (Etienne Muller)

: Good idea

: Except at the ends of the boat there will be very little (if none at all)
: chamfering required

Et,

I'm not following you. Near amidships is where very little chamfering is needed. As you approach the ends the strips cross the forms at a greater angle.

Len Thunberg

Messages In This Thread

Strip: Forms on the Strongback
DaveS -- 6/20/2008, 9:12 am
Relief
DaveS -- 6/20/2008, 1:09 pm
Re: Relief
Bill Hamm -- 6/21/2008, 9:09 am
Re: Relief
DaveS -- 6/23/2008, 10:38 am
Re: Strip: Forms on the Strongback
Len Thunberg -- 6/20/2008, 11:54 am
Re: Strip: Forms on the Strongback
Etienne Muller -- 6/21/2008, 6:45 am
Re: Strip: Forms on the Strongback
Len Thunberg -- 6/21/2008, 4:16 pm
Re: Strip: Forms on the Strongback
Etienne Muller -- 6/22/2008, 6:20 am
Re: Strip: Forms on the Strongback
DaveS -- 6/23/2008, 10:26 am
Re: Strip: Forms on the Strongback
Todd Sullivan -- 6/20/2008, 10:09 am