Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Other: Sealing Plywood?
In Response To: Other: Sealing Plywood? (Michael Collins)
If you decide to redo the frames in marine ply you could speed up the job by using using a collared router bit with the old frames as templates.
Et
Messages In This Thread
- Other: Sealing Plywood?
Michael Collins -- 7/5/2008, 7:57 pm- Re: Other: Sealing Plywood?
Etienne Muller -- 7/6/2008, 1:15 pm- Re: Other: Sealing Plywood?
HenkA -- 7/6/2008, 2:13 am- Re: Other: Sealing Plywood?
Bill Hamm -- 7/6/2008, 1:54 am- Re: Other: Sealing Plywood?
Bill Hamm -- 7/6/2008, 1:52 am- Re: Other: Sealing Plywood?
Michael Collins -- 7/6/2008, 11:20 am
- Is the water is warm and shallow where you paddle?
Dave Gentry -- 7/5/2008, 9:00 pm- Marine Polyurethane Enamel
Michael Collins -- 7/6/2008, 12:42 am- Re: Is the water is warm and shallow where you pad
Michael Collins -- 7/5/2008, 10:05 pm- Re: Is the water is warm and shallow where you pad
Carl Delo -- 7/5/2008, 11:44 pm- Re: Is the water is warm and shallow where you pad
Michael Collins -- 7/6/2008, 12:26 am
- Re: Is the water is warm and shallow where you pad
- Re: Is the water is warm and shallow where you pad
- Re: Other: Sealing Plywood?
Peter Sebbage -- 7/5/2008, 8:52 pm- Re: Other: Sealing Plywood?
Michael Collins -- 7/5/2008, 10:09 pm
- Re: Other: Sealing Plywood?
- Re: Other: Sealing Plywood?
