Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Fiberglass bulkheads
By:Gary Dierking
Date: 8/5/2008, 4:31 pm
In Response To: Strip: Fiberglass bulkheads *LINK* *Pic* (Bryan Hansel)

I didn't know there was a special matt for epoxy. Is this like CSM without the chemical binders that don't dissolve in epoxy?

: I finished putting in my all fiberglass bulkheads today. I ended up making
: them out of 1.5 ounce epoxy mat and 5 ounce tight weave.

Messages In This Thread

Strip: Fiberglass bulkheads *LINK* *Pic*
Bryan Hansel -- 8/4/2008, 5:56 pm
Re: Strip: Fiberglass bulkheads
Gary Dierking -- 8/5/2008, 4:31 pm
Re: Strip: Fiberglass bulkheads
Bryan Hansel -- 8/6/2008, 1:26 am
Angled Bulkheads
Mike Bielski -- 8/4/2008, 9:26 pm
Re: Angled Bulkheads
Bryan Hansel -- 8/4/2008, 11:58 pm
Re: Angled Bulkheads
Mike Bielski -- 8/5/2008, 12:37 am
Re: Angled Bulkheads
Bryan Hansel -- 8/5/2008, 12:47 am
Re: Angled Bulkheads *Pic*
Dave Houser -- 8/5/2008, 3:59 pm
Re: Angled Bulkheads *Pic*
Andy Waddington -- 8/21/2008, 12:53 pm
Re: Angled Bulkheads
Bryan Hansel -- 8/21/2008, 11:28 pm
Aft Bulkheads and space behind the seat.
jesper -- 8/7/2008, 4:16 am
Re: Aft Bulkheads and space behind the seat.
tkennefick -- 8/21/2008, 4:23 pm
Re: Aft Bulkheads and space behind the seat.
Bill Hamm -- 8/22/2008, 1:45 am
Re: Angled Bulkheads
Bryan Hansel -- 8/6/2008, 1:24 am
Re: Angled Bulkheads
Dan Caouette (CSFW) -- 8/6/2008, 8:28 am
Re: Angled Bulkheads
Mike Bielski -- 8/6/2008, 11:27 am