Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Demijohn *Pic*
By:Jerry
Date: 8/27/2008, 10:13 pm
In Response To: Demijohn (Donald)

: Can you shorten it a little? I'd love to know what you do with that.

Ok, I'll try a short story version. A good kayaking friend was getting married. He wanted everyone at the reception to partake in one of his favorite beverages. SANGRIA So, during a night of barley pop drinking a few months before before the wedding, he was discussing this wish with a fellow kayaking friend. The friend says "no problem, Jerry and I will figure something out. You don't worry about it." A few days later I was filled in to the conversation and that I was volunteered into this interesting project. This is what we came up with. One of the requirements from the groom was that the demijohn had to be as visible as possible. The recipe used was "imported' from Spain, when he was there for the running of the bulls. The guy I built this apparatus with was on that Spain trip with him. It's the one trip I regret not doing with them. Anyway, the apparatus was a success at the wedding.

Hope I haven't bored you to much.

Jerry

Messages In This Thread

Paddle: laminating a bent shaft *LINK* *Pic*
Doug Smith -- 8/26/2008, 12:25 pm
Re: Paddle: laminating a bent shaft
Allan -- 8/28/2008, 2:00 am
Re: Paddle: laminating a bent shaft *Pic*
Jerry -- 8/26/2008, 10:56 pm
Demijohn
Donald -- 8/27/2008, 2:03 pm
Re: Demijohn *Pic*
Jerry -- 8/27/2008, 10:13 pm
Re: Demijohn
Donald -- 8/28/2008, 8:24 am
Re: Demijohn *Pic*
Jerry -- 8/28/2008, 1:29 pm
Re: Demijohn
Donald -- 8/28/2008, 1:39 pm
Re: Paddle: laminating a bent shaft
Doug Smith -- 8/26/2008, 11:27 pm
Re: Paddle: laminating a bent shaft *LINK*
Glen Smith -- 8/26/2008, 7:15 pm
Re: Paddle: laminating a bent shaft
Doug Smith -- 8/26/2008, 7:24 pm
Re: Paddle: laminating a bent shaft
JohnK -- 8/26/2008, 7:06 pm
Re: Paddle: laminating a bent shaft
Allan -- 8/26/2008, 5:36 pm
Re: Paddle: laminating a bent shaft
Doug Smith -- 8/26/2008, 5:43 pm
Re: Paddle: laminating a bent shaft
Allan -- 8/26/2008, 5:25 pm
Re: Paddle: laminating a bent shaft
Kudzu -- 8/26/2008, 1:22 pm