: Hello All,
: I drilled and filled the holes for my deck rigging and perimeter line. The
: line will terminate at the ends of the fore and aft decks. Last night,
: admiring my work, I realized that my ares are not long enough to reach
: that far into the boat through the hatches to put a nut on the end of the
: bolt. I've had a few ideas floating around like hot gluing the nut and
: washers to a stick or the end of a box end wrench. I will be using
: stainless steel fasteners and webbing. Any other ideas?
: Thanks,
: Dave

Other possibility is to glue (epoxy) a block of wood into the ends, block can be long enough to enable you to reach it then weight it as a clamp [obviously boat has to be upside down for this to work] then use stainless wood screws for the ends instead of screws and nuts.

Bill H.