Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Repair Advice, Please - S&G Hull Crack
By:Etienne Muller
Date: 10/3/2008, 10:26 am
In Response To: Re: S&G: Repair Advice, Please - S&G Hull Crack (Dave Reekie)

: Et's method is specifically designed for cases where the inside of the area
: to be repaired is inaccessible. You need to be able to push the backing
: piece through the hole from the outside. You can get a 4"x6"
: rectangle through a 2"x4" hole OK. It's harder to get a 4"
: circle through a 2" circular hole ;-)

: If you have access to the inside then a circle would be fine, and you'd have
: no need of the string to pull it into position etc etc.

: Dave.

Thanks Dave. You said it all

Et

Messages In This Thread

S&G: Repair Advice, Please - S&G Hull Crack
vk1nf -- 10/1/2008, 9:54 am
Re: S&G: Repair Advice, Please - S&G Hull Crack
Paul G. Jacobson -- 10/6/2008, 12:36 pm
Re: S&G: Repair Advice, Please - S&G Hull Crack
Terry Haines -- 10/6/2008, 11:56 pm
Re: S&G: Repair Advice, Please - S&G Hull Crack
Etienne Muller -- 10/2/2008, 2:02 pm
Re: S&G: Repair Advice, Please - S&G Hull Crack
Bill Hamm -- 10/2/2008, 3:56 pm
Re: S&G: Repair Advice, Please - S&G Hull Crack
Dave Reekie -- 10/3/2008, 4:21 am
Re: S&G: Repair Advice, Please - S&G Hull Crack
Bill Hamm -- 10/3/2008, 12:14 pm
Re: S&G: Repair Advice, Please - S&G Hull Crack
Etienne Muller -- 10/4/2008, 2:09 pm
Re: S&G: Repair Advice, Please - S&G Hull Crack
Bill Hamm -- 10/5/2008, 2:18 am
Re: S&G: Repair Advice, Please - S&G Hull Crack
Etienne Muller -- 10/3/2008, 10:26 am
Re: S&G: Repair Advice, Please - S&G Hull Crack
Mike Savage -- 10/1/2008, 11:46 am
Re: S&G: Repair Advice, Please - S&G Hull Crack
David Kennedy -- 10/1/2008, 11:03 am
Re: S&G: Repair Advice, Please - S&G Hull Crack
Bill Hamm -- 10/1/2008, 12:25 pm