Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Skin-on-Frame: Yost Sea Flea - Keel
In Response To: Skin-on-Frame: Yost Sea Flea - Keel *LINK* *Pic* (Doug S)
Doug,
You can just make the bottom of the keel match the offset point. Just be sure
to trim the cross sections (concave) and leave 1/4" above the keel for skin to
cross section clearance. Cut out the center of the cross section to leave
about an inch of cross section above the keel for strength.
Tom
Messages In This Thread
- Skin-on-Frame: Yost Sea Flea - Keel *LINK* *Pic*
Doug S -- 1/5/2009, 9:25 am- Re: Skin-on-Frame: Yost Sea Flea - Keel
Tom Yost -- 1/5/2009, 10:47 am- Thanks *LINK* *Pic*
Doug S -- 1/6/2009, 10:17 am- Re: Thanks *LINK*
Tom Yost -- 1/6/2009, 11:10 am- Very cool! Thanks again. *NM*
Doug S -- 1/6/2009, 11:22 am
- Very cool! Thanks again. *NM*
- Re: Thanks *LINK*
- Thanks *LINK* *Pic*
- Re: Skin-on-Frame: Yost Sea Flea - Keel
