Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: Brush or Roll on oil based spar
By:Bill Hamm
Date: 2/5/2009, 2:24 pm
In Response To: Re: Skin-on-Frame: Brush or Roll on oil based spar (Phil Nelson)

: What about using a squeegee ?

Can't imagine how you'd do that, varnish isn't anywhere near as thick as epoxy, would run all over the place trying that.

Best roller's for varnish are those sold for resin, either those sold by the epoxy companies or the candy stripe ones sold by commercial auto supply houses.

Bill H.

Messages In This Thread

Skin-on-Frame: Brush or Roll on oil based spar urethane?
Brent -- 4/17/2008, 4:34 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 4/20/2008, 9:39 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 4/21/2008, 2:10 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Phil Nelson -- 2/5/2009, 6:22 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 2/5/2009, 2:24 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 2/6/2009, 9:51 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 2/6/2009, 9:56 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 2/5/2009, 7:44 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Phil Nelson -- 2/5/2009, 10:40 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 2/6/2009, 9:45 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 2/6/2009, 9:54 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Glen Smith -- 2/6/2009, 12:00 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Scott Shurlow -- 4/18/2008, 6:26 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 4/20/2008, 1:06 am
Re: Skin-on-Frame: Brush or Roll on oil based spar
Brian Nystrom -- 4/20/2008, 9:35 am
Darin Wright
Blanche Barnes -- 11/13/2008, 2:14 am
*SPAM* *NM*
Greg H -- 11/14/2008, 12:46 pm
Re: Skin-on-Frame: Brush or Roll on oil based spar
Bill Hamm -- 4/21/2008, 2:07 am