Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Strips into thickness planner?
By:Paul Lueders
Date: 2/7/2009, 11:49 am
In Response To: Re: Material: Strips into thickness planner? (Paul G. Jacobson)

:When I said I might cut strips bigger that 1/4, I would only do this so I could take a little off each side of the strips in my surface planner to bring it down to a perfect 1/4" and very smooth on each side.
Sorry for the confusion. I agree with everything you said.
Thanks, Paul

Messages In This Thread

Material: Strips into thickness planner?
Paul Lueders -- 2/6/2009, 1:49 pm
Re: Material: Strips into thickness planner?
Paul G. Jacobson -- 2/7/2009, 11:04 am
Re: Material: Strips into thickness planner?
Terry Haines -- 2/10/2009, 11:41 am
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/7/2009, 11:49 am
Re: Material: Strips into thickness planner?
Etienne Muller------WebKitFormBoundary3t+uojWj1lA6 -- 2/7/2009, 1:09 pm
Everything Clayton said. *NM*
Roy Morford -- 2/7/2009, 1:19 pm
Re: Everything Clayton said.
Daniel from sweden -- 2/7/2009, 2:12 pm
Re: Everything Clayton said.
Bill Hamm -- 2/8/2009, 12:26 am
Re: Everything Clayton said.
Roy Morford -- 2/8/2009, 12:19 pm
Re: Everything Clayton said.
Bill Hamm -- 2/9/2009, 1:02 am
Re: Everything Clayton said.
Mike Savage -- 2/7/2009, 5:02 pm
Re: Everything Clayton said.
Paul Lueders -- 2/7/2009, 5:01 pm
Re: Material: Strips into thickness planner?
don f -- 2/7/2009, 10:44 am
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/7/2009, 11:58 am
Re: Material: Strips into thickness planner?
don f -- 2/8/2009, 11:18 am
Re: Material: Strips into thickness planner?
Bill Hamm -- 2/9/2009, 12:58 am
Re: Material: Strips into thickness planner?
Clayton Plunkett -- 2/6/2009, 7:42 pm
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/6/2009, 10:05 pm
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/6/2009, 10:04 pm
Re: Material: Strips into thickness planner?
Pedro Almeida -- 2/6/2009, 6:37 pm
Re: Material: Strips into thickness planner?
Kudzu -- 2/6/2009, 5:14 pm