Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Material: Strips into thickness planner?
By:Bill Hamm
Date: 2/9/2009, 12:58 am
In Response To: Re: Material: Strips into thickness planner? (don f)

: Hi
: I probably have four or five going through at a time. I'm taking off very
: little so there is no strain on the planner. I do a continuous feed so one
: person on one side, another person on the other side and just keep putting
: strips in. I did find if I tried for too many, they could get crossed
: ruining a strip or jamming. We generally did enough for three or four
: boats at a time but it still went quite quickly. I've done all my boats
: (10 including canoes) at 3/16 of an inch so having all the strips the same
: thickness really helps prevent sanding through (which creates a whole
: other set of problems -- surmountable but still a challenge)
: good luck
: don

Would certainly be helpful to have two people for this, not required though.

Bill H.

Messages In This Thread

Material: Strips into thickness planner?
Paul Lueders -- 2/6/2009, 1:49 pm
Re: Material: Strips into thickness planner?
Paul G. Jacobson -- 2/7/2009, 11:04 am
Re: Material: Strips into thickness planner?
Terry Haines -- 2/10/2009, 11:41 am
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/7/2009, 11:49 am
Re: Material: Strips into thickness planner?
Etienne Muller------WebKitFormBoundary3t+uojWj1lA6 -- 2/7/2009, 1:09 pm
Everything Clayton said. *NM*
Roy Morford -- 2/7/2009, 1:19 pm
Re: Everything Clayton said.
Daniel from sweden -- 2/7/2009, 2:12 pm
Re: Everything Clayton said.
Bill Hamm -- 2/8/2009, 12:26 am
Re: Everything Clayton said.
Roy Morford -- 2/8/2009, 12:19 pm
Re: Everything Clayton said.
Bill Hamm -- 2/9/2009, 1:02 am
Re: Everything Clayton said.
Mike Savage -- 2/7/2009, 5:02 pm
Re: Everything Clayton said.
Paul Lueders -- 2/7/2009, 5:01 pm
Re: Material: Strips into thickness planner?
don f -- 2/7/2009, 10:44 am
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/7/2009, 11:58 am
Re: Material: Strips into thickness planner?
don f -- 2/8/2009, 11:18 am
Re: Material: Strips into thickness planner?
Bill Hamm -- 2/9/2009, 12:58 am
Re: Material: Strips into thickness planner?
Clayton Plunkett -- 2/6/2009, 7:42 pm
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/6/2009, 10:05 pm
Re: Material: Strips into thickness planner?
Paul Lueders -- 2/6/2009, 10:04 pm
Re: Material: Strips into thickness planner?
Pedro Almeida -- 2/6/2009, 6:37 pm
Re: Material: Strips into thickness planner?
Kudzu -- 2/6/2009, 5:14 pm