Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: question about external laminated stems
By:Ric Moodie
Date: 2/24/2009, 5:35 pm
In Response To: Strip: question about external laminated stems *Pic* (Chris Sperry)

Another way of doing a laminated stem is to flatten the deck portion of the bow/stern ie. above the sheer. So you just continue the flattening that you have prepared already on the hull. Then wrap the lamination strips around the whole end, from the hull right up around the end and a few inches onto the deck. When you are ready to separate the deck and hull, after glassing, you just cut through the laminated stems with a pull saw.

Ric

Messages In This Thread

Strip: question about external laminated stems *Pic*
Chris Sperry -- 2/22/2009, 12:39 pm
Re: Strip: question about external laminated stems
Ric Moodie -- 2/24/2009, 5:35 pm
Re: Strip: question about external laminated stems
Chris Sperry -- 2/25/2009, 7:17 am
Re: Strip: question about external laminated stems
Scott Fitzgerrell -- 2/22/2009, 4:38 pm
Re: Strip: question about external laminated stems
Chris Sperry -- 2/22/2009, 7:08 pm
Put a head on it. *Pic*
Brian -- 2/22/2009, 2:36 pm
Re: Put a head on it.
JohnK -- 2/23/2009, 10:40 pm
Re: Put a head on it.
Etienne Muller -- 2/24/2009, 5:27 pm
Re: Put a head on it.
JohnK -- 2/24/2009, 8:09 pm
Re: Put a head on it.
Scott Fitzgerrell -- 2/24/2009, 10:55 pm
That's fun! Nice job Brian. Thank you *NM*
Chris Sperry -- 2/22/2009, 3:46 pm
Re: Strip: question about external laminated stems *Pic*
tony olsen -- 2/22/2009, 1:48 pm
Very nicely done. Thanks Tony *NM*
Chris Sperry -- 2/22/2009, 3:45 pm
another pic *NM* *Pic*
Chris Sperry -- 2/22/2009, 12:40 pm