Sounds like a pretty good plan, but if the hot glue is really stuck, I'd at least free it up from the hull immediately after the flip. You can run a very thin wire or cable between the form and the hull to separate the two, much like when they remove a windshield.
Good luck!
tony

: I'm thinking: -sand, fair, and fiberglass the hull now
: -flip the hull, trim the fiberglass at the sheer and begin stripping the deck
: -get a good start on the deck, at least the sheer and a few more strip in
: -detach the hull from the forms for the first time by removing hot glue from
: inside the hull
: -finish stripping the deck
: -fair, sand and fiberglass the deck
: -cut in the cockpit coaming and hatches
: -fair, sand and fiberglass insides of both hull and deck

: Does this sound right?