Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Removing the Cu wires is easy...
By:Robert N Pruden
Date: 5/13/2009, 2:40 pm
In Response To: Re: S&G: Filling Stitch Holes (Brian Scaborough)

When you are ready to remove the wires, cut the loop and heat with a soldering iron while gently pulling on the wire. Within seconds the wire slips out of the hole.

Robert N Pruden

Messages In This Thread

S&G: Filling Stitch Holes
Howard H -- 5/4/2009, 8:40 am
Re: S&G: Filling Stitch Holes
Dan R -- 5/11/2009, 12:59 pm
Re: S&G: Filling Stitch Holes
Brian Scaborough -- 5/13/2009, 2:00 pm
Removing the Cu wires is easy...
Robert N Pruden -- 5/13/2009, 2:40 pm
Re: Removing the Cu wires is easy...
Craig Robinson -- 5/16/2009, 3:28 am
Re: S&G: Filling Stitch Holes
ogata -- 5/13/2009, 2:20 pm
Re: S&G: Filling Stitch Holes
Brian Scaborough -- 5/15/2009, 10:20 am
Stitch Holes? Ha. *Pic*
Dave Gentry -- 5/10/2009, 7:28 pm
Re: Stitch Holes? Ha.
Etienne Muller -- 5/12/2009, 5:59 pm
Re: S&G: Filling Stitch Holes
Bill Hamm -- 5/7/2009, 12:42 am
Re: S&G: Filling Stitch Holes
Larry C. -- 5/6/2009, 7:25 pm
Re: S&G: Filling Stitch Holes
Howard H -- 5/7/2009, 12:17 pm
Re: S&G: Filling Stitch Holes *Pic*
Howard Girfer -- 5/10/2009, 6:59 pm
sorry for the eye test - try this one *NM* *Pic*
Howard Girer -- 5/10/2009, 7:07 pm
Filling Stitch Holes
Jay Babina -- 5/4/2009, 9:46 am
I have filled the holes in the past but not now...
Robert N Pruden -- 5/4/2009, 10:58 am
Re: S&G: Filling Stitch Holes
wwfloyd -- 5/4/2009, 9:14 am