Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Skin-on-Frame: converting ft-cm
By:Dave Gentry
Date: 5/31/2009, 5:02 pm
In Response To: Skin-on-Frame: converting ft-cm (bueller)

: I have just started the yost Sea Rider.The table of offsets for the sea rider
: are in feet as the other yost boats are in cm.It says (ftx12)x2.54=cm to
: convert.Lets say at its widest HB at section 4 is .811 ft would be 24.7
: cm.Is that right? It doesn't seem that there will be any leg room or room
: for feet. I am building this for my wife whom is very short but it seems
: it will be small even for her.

Well, 24.7 cm is about 9 3/4", and that's a HB. The boat is 19 1/2" wide, so about 9 3/4" is just about exactly half the beam. So, yes, that's right.

But it seems you are referring to the deck heights? That would be the HAB (height above baseline). I agree that there's not just tons of leg room, but it'll be OK. If you feel like it's needed, it's very easy to just make the deckridge - at the masik - an inch or so higher. I've done it plenty. Don't make things higher at the chines, though!

Good luck!
Dave

Messages In This Thread

Skin-on-Frame: converting ft-cm
bueller -- 5/31/2009, 10:31 am
Re: Skin-on-Frame: converting ft-cm
Robert N Pruden -- 6/2/2009, 12:05 pm
Re: Skin-on-Frame: converting ft-cm
Andy Waddington -- 6/2/2009, 4:07 pm
Re: Skin-on-Frame: converting ft-cm
Brian Scaborough -- 6/2/2009, 10:16 am
Re: Skin-on-Frame: converting ft-cm
Bill Hamm -- 6/3/2009, 1:21 am
Re: Skin-on-Frame: converting ft-cm *LINK*
Doug S -- 6/1/2009, 2:22 pm
Re: Skin-on-Frame: converting ft-cm *LINK*
Phil Nelson -- 6/1/2009, 8:15 pm
Re: Skin-on-Frame: converting ft-cm
Bill Hamm -- 6/1/2009, 12:34 am
Re: Skin-on-Frame: converting ft-cm
Dave Gentry -- 5/31/2009, 5:02 pm