Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: starting those first strips
By:george jung
Date: 7/7/2009, 11:24 pm
In Response To: Re: Strip: starting those first strips (Bill Hamm)

: I'm assuming you're buying pre-cut strips?

: Not much available other than standard widths that I've seen anyway.

: Bill H.

No pre-cuts - my intent is to see if I can build one 'from scratch'. I've set up a table saw based on the multiple times that's been discussed here. Now it 's just a matter of getting the material, and getting started.

Messages In This Thread

Strip: starting those first strips
george jung -- 7/3/2009, 7:59 pm
Re: Strip: starting those first strips *LINK*
Rod Tait -- 7/5/2009, 12:19 pm
Don't worry
Jay Babina -- 7/5/2009, 10:48 am
Re: Don't worry
george jung -- 7/6/2009, 12:01 am
Re: Don't worry
george jung -- 7/5/2009, 7:49 pm
Storm LT building log
Jay Babina -- 7/5/2009, 9:19 pm
Re: Strip: starting those first strips
Bill Hamm -- 7/5/2009, 12:19 am
Re: Strip: starting those first strips
george jung -- 7/5/2009, 10:04 am
Re: Strip: starting those first strips
Bill Hamm -- 7/6/2009, 12:28 am
Re: Strip: starting those first strips
Bill Hamm -- 7/6/2009, 12:25 am
Re: Strip: starting those first strips
george jung -- 7/6/2009, 9:14 am
Re: Strip: starting those first strips
Bill Hamm -- 7/6/2009, 8:11 pm
Re: Strip: starting those first strips
george jung -- 7/7/2009, 12:00 am
Re: Strip: starting those first strips
Bill Hamm -- 7/7/2009, 8:21 pm
Re: Strip: starting those first strips
george jung -- 7/7/2009, 11:24 pm
Re: Strip: starting those first strips
Bill Hamm -- 7/12/2009, 12:50 am
Re: Strip: starting those first strips
Kurt Maurer -- 7/4/2009, 7:03 pm
Re: Strip: starting those first strips
george jung -- 7/4/2009, 9:27 pm