Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Shortening a stripper
By:risto
Date: 7/15/2009, 5:48 am
In Response To: Re: Strip: Shortening a stripper (fred g)

: 10% is the general rule. You need to modify your stem forms to match.

hi,

this is bjorn thomasson also says. I built his Njord 10% shorter and it works very well - very little effort needed for a good cruising pace due to low wet area.

I did not modify the inner stems at all. Made the deck over but that is another story, all about certain type of hatches.

greetins, i recommend shortening,

risto

Messages In This Thread

Strip: Shortening a stripper
Glenn -- 7/14/2009, 10:40 pm
Re: Strip: Shortening a stripper
Joy -- 7/16/2009, 4:21 pm
Re: Strip: Shortening a stripper
Nick Schade - Guillemot Kayaks -- 7/16/2009, 9:21 am
Strip: Shortening a stripper ------WebKitFormBound
Jay Babina ------WebKitFormBoundarysuL863lZ+g2bA8N -- 7/16/2009, 8:03 am
Re: Strip: Shortening a stripper
fred g -- 7/14/2009, 10:58 pm
Re: Strip: Shortening a stripper
risto -- 7/15/2009, 5:48 am
Re: Strip: Shortening a stripper
Allan -- 7/15/2009, 6:19 am