Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: joining the halves
By:Etienne Muller
Date: 9/25/2009, 10:58 am
In Response To: Re: Strip: joining the halves (Pawistik)

: Doesn't that then interfere with applying the tape at the inside seam? Having
: the bulkhead in place means that the majority of the seam MUST be reached
: through the hatches, which must therefore be large enough to accommodate
: this. I added mine after and I agree that that would have been simplest in
: some ways, I think it creates another problem.
: Bryan

I use a sheer-plank. I hate glassing inside holes and avoid it if possible.

Et

Messages In This Thread

Strip: joining the halves
Les Cheeseman -- 9/20/2009, 5:55 am
Re: Strip: joining the halves
Rob Macks / Laughing Loon CC&K -- 9/22/2009, 11:20 am
Re: Strip: joining the halves
Jay Babina -- 9/21/2009, 1:28 pm
Re: Strip: joining the halves
george jung -- 9/21/2009, 1:54 pm
Strip: joining the halves
Jay Babina -- 9/22/2009, 8:56 am
Re: Strip: joining the halves
Bill Hamm -- 9/22/2009, 12:55 am
Re: Strip: joining the halves
Steve Rasmussen -- 9/21/2009, 8:47 am
Re: Strip: joining the halves
Ric -- 9/20/2009, 7:46 pm
Re: Strip: joining the halves
george jung -- 9/20/2009, 8:54 pm
Re: Strip: joining the halves
Bill Hamm -- 9/21/2009, 12:08 am
Re: Strip: joining the halves
Etienne Muller -- 9/20/2009, 5:03 pm
Re: Strip: joining the halves
Pawistik -- 9/21/2009, 12:57 pm
Re: Strip: joining the halves
Etienne Muller -- 9/25/2009, 10:58 am
Re: Strip: joining the halves
Bill Hamm -- 9/25/2009, 3:04 pm