Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Strip Build Novice Present Unknowns
By:Allan
Date: 10/1/2009, 5:23 pm
In Response To: Strip: Strip Build Novice Present Unknowns (Tony Jackman)

When I was using PVA glue at about 6C, it went white and didn't set. My solution was to warm it with the heat gun enough to make it just begin to turn clear. That seemed to be enough to get it started so that it set in a reasonable time.

Heating my shed wasn't an option, so I just warmed up the glue joint.

Messages In This Thread

Strip: Strip Build Novice Present Unknowns
Tony Jackman -- 10/1/2009, 7:10 am
Re: Strip: Strip Build Novice... Cold weather...
William Cruz -- 10/1/2009, 9:28 pm
Re: Strip: Strip Build Novice... Cold weather...
Reg_B -- 10/2/2009, 7:58 am
Re: Strip: Strip Build Novice Present Unknowns
Allan -- 10/1/2009, 5:23 pm
Re: Strip: Strip Build Novice Present Unknowns
Deano -- 10/1/2009, 1:19 pm
Re: Strip: Strip Build Novice Present Unknowns
Reg_B -- 10/1/2009, 3:43 pm
Re: Strip: Strip Build Novice Present Unknowns
Wesley Ewell -- 10/1/2009, 12:30 pm
Re: Strip: Strip Build Novice Present Unknowns
Bill Hamm -- 10/1/2009, 10:38 am