Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Routing bead and cove
By:Mrkim
Date: 10/2/2009, 9:01 am

In my studies I ran into a difference in the way the strips were routed. One book says feed strips against the rotation of the bit and another with the rotation. Is there much of a difference which way?

Thanks
Kim

Messages In This Thread

Strip: Routing bead and cove
Mrkim -- 10/2/2009, 9:01 am
Re: Strip: Routing bead and cove
JohnK -- 10/3/2009, 4:43 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/4/2009, 12:22 am
Re: Strip: Routing bead and cove
JohnK -- 10/5/2009, 12:36 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/6/2009, 2:12 am
Re: Strip: Routing bead and cove
Deano -- 10/2/2009, 12:53 pm
Re: Strip: Routing bead and cove
Ken Blanton -- 10/2/2009, 5:27 pm
wrong is sometime right..
Larry C. -- 10/2/2009, 6:16 pm
Re: wrong is sometime right..
Mrkim -- 10/3/2009, 12:03 am
Re: Strip: Routing bead and cove
Wesley Ewell -- 10/2/2009, 1:18 pm
.02 cents from a former machinist
Reg Lake -- 10/3/2009, 12:56 am
Re: Strip: Routing bead and cove
Etienne Muller -- 10/2/2009, 2:16 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 4:27 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 10:35 am
Re: Strip: Routing bead and cove
Paul G. Jacobson -- 10/2/2009, 9:23 am