Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Routing bead and cove
By:Etienne Muller
Date: 10/2/2009, 2:16 pm
In Response To: Re: Strip: Routing bead and cove (Wesley Ewell)

: Yet this is how Vaclav Stejskal of One Ocean Kayaks does it. He uses two
: finger boards to control the speed of the strip through the router.
: Machinists always feed their work through milling machines this way, as it
: leaves a smoother finish.

It would be moot if you didn't bother doing the B&C at all.

Et

Messages In This Thread

Strip: Routing bead and cove
Mrkim -- 10/2/2009, 9:01 am
Re: Strip: Routing bead and cove
JohnK -- 10/3/2009, 4:43 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/4/2009, 12:22 am
Re: Strip: Routing bead and cove
JohnK -- 10/5/2009, 12:36 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/6/2009, 2:12 am
Re: Strip: Routing bead and cove
Deano -- 10/2/2009, 12:53 pm
Re: Strip: Routing bead and cove
Ken Blanton -- 10/2/2009, 5:27 pm
wrong is sometime right..
Larry C. -- 10/2/2009, 6:16 pm
Re: wrong is sometime right..
Mrkim -- 10/3/2009, 12:03 am
Re: Strip: Routing bead and cove
Wesley Ewell -- 10/2/2009, 1:18 pm
.02 cents from a former machinist
Reg Lake -- 10/3/2009, 12:56 am
Re: Strip: Routing bead and cove
Etienne Muller -- 10/2/2009, 2:16 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 4:27 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 10:35 am
Re: Strip: Routing bead and cove
Paul G. Jacobson -- 10/2/2009, 9:23 am