Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Routing bead and cove
By:Bill Hamm
Date: 10/6/2009, 2:12 am
In Response To: Re: Strip: Routing bead and cove (JohnK)

: Hi Bill,
: Its always risky I guess. Care has to be taken everyway one does things with
: high speed machinery. I guess we work to minimize the risk especially if
: what we are doing is risky. I love my fingers. Can't hold a paddle without
: them.
: JohnK

Hi John,

Many years back when I had the commercial shop, I managed to run one hand thru an electric plane, lost a considerable amount of skin and blood but it healed (eventually). My fingers still tingle when I start a machine that can hurt me, so I think safety every time. Trust me, you don't want this experience.

Btw, friends were coming to the shop and had keys to the place, to help me lift a deck onto a completed sailboat hull that same day. When they got there they never found me, just a large trail of blood. They later said they were following the trail looking for a body at the end (was a very large shop, 155 ft. end to end with several rooms). Just as they reached the end of the trail I showed back up from the emergency room with my left hand about 3 times bigger wrapped in bandages :)

Bill H.

Messages In This Thread

Strip: Routing bead and cove
Mrkim -- 10/2/2009, 9:01 am
Re: Strip: Routing bead and cove
JohnK -- 10/3/2009, 4:43 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/4/2009, 12:22 am
Re: Strip: Routing bead and cove
JohnK -- 10/5/2009, 12:36 am
Re: Strip: Routing bead and cove
Bill Hamm -- 10/6/2009, 2:12 am
Re: Strip: Routing bead and cove
Deano -- 10/2/2009, 12:53 pm
Re: Strip: Routing bead and cove
Ken Blanton -- 10/2/2009, 5:27 pm
wrong is sometime right..
Larry C. -- 10/2/2009, 6:16 pm
Re: wrong is sometime right..
Mrkim -- 10/3/2009, 12:03 am
Re: Strip: Routing bead and cove
Wesley Ewell -- 10/2/2009, 1:18 pm
.02 cents from a former machinist
Reg Lake -- 10/3/2009, 12:56 am
Re: Strip: Routing bead and cove
Etienne Muller -- 10/2/2009, 2:16 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 4:27 pm
Re: Strip: Routing bead and cove
Bill Hamm -- 10/2/2009, 10:35 am
Re: Strip: Routing bead and cove
Paul G. Jacobson -- 10/2/2009, 9:23 am