Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Cutting Strips
By:Mrkim
Date: 10/8/2009, 5:40 pm

Just received my rough wood for strips. It is 1.125" to 1.24" thick. I don't have a planer. Would it work out to cut them the 1/4" thickness then run them through the table saw again (actually twice, once for each rough side) for the 3/4" width? Or should I buy a planer or pay to have them run through one? I am not actually doing it now because my table saw went out on me this week and I won't get a new one for another week.

Thanks
Kim

Messages In This Thread

Strip: Cutting Strips
Mrkim -- 10/8/2009, 5:40 pm
Re: Strip: Cutting Strips
Fred Gasper -- 10/9/2009, 6:52 pm
Re: Strip: Cutting Strips
fred graus -- 10/9/2009, 9:09 am
Re: Strip: Cutting Strips *NM* *Pic*
Mrkim -- 10/9/2009, 1:49 pm
Re: Strip: Cutting Strips *Pic*
Mrkim -- 10/9/2009, 1:53 pm
Re: Strip: Cutting Strips *Pic*
fred graus -- 10/9/2009, 3:06 pm
Re: Strip: Cutting Strips
Ed Darlington -- 10/10/2009, 5:46 am
Re: Strip: Cutting Strips
Mac McCaskie -- 10/17/2009, 5:42 pm
Re: Strip: Cutting Strips
Bill Hamm -- 10/11/2009, 12:31 am
Re: Strip: Cutting Strips
Mrkim -- 10/9/2009, 3:24 pm
Re: Strip: Cutting Strips
fred graus -- 10/9/2009, 3:44 pm
Re: Strip: Cutting Strips
Allan -- 10/9/2009, 9:56 pm
Re: Strip: Cutting Strips
Mrkim -- 10/9/2009, 4:17 pm
Re: Strip: Cutting Strips *LINK*
Ian Johnson -- 10/9/2009, 5:04 pm
Re: Strip: Cutting Strips *Pic*
Etienne Muller -- 10/9/2009, 6:26 am
Re: Strip: Cutting Strips
Mrkim -- 10/9/2009, 8:13 am
Re: Strip: Cutting Strips
Bill Hamm -- 10/10/2009, 1:33 am
Re: Strip: Cutting Strips
Brian Nystrom -- 10/9/2009, 8:18 pm
Re: Strip: Cutting Strips
Mac McCaskie -- 10/8/2009, 11:45 pm
Re: Strip: Cutting Strips
Bill Hamm -- 10/8/2009, 5:54 pm
Re: Strip: Cutting Strips
Terry Haines -- 10/11/2009, 12:56 am