Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Cutting Strips
By:Bill Hamm
Date: 10/10/2009, 1:33 am
In Response To: Re: Strip: Cutting Strips (Mrkim)

: I think you guys may have talked me into getting a planer. I got a band saw
: when a buddy wanted to do a trade. I use that tons more than I thought I
: would. Hopefully the planer will be the same.

: On the comment that I don't have to stick with 3/4" width. I am sure
: gonna try to see if I can bend an inch enough. I sure would save a lot of
: expensive wood.

: Thanks to all
: Kim

I used to use my table saw for everything until I got the bandsaw, now I use it for almost everything and only use the table saw for long cuts.

Bill H.

Messages In This Thread

Strip: Cutting Strips
Mrkim -- 10/8/2009, 5:40 pm
Re: Strip: Cutting Strips
Fred Gasper -- 10/9/2009, 6:52 pm
Re: Strip: Cutting Strips
fred graus -- 10/9/2009, 9:09 am
Re: Strip: Cutting Strips *NM* *Pic*
Mrkim -- 10/9/2009, 1:49 pm
Re: Strip: Cutting Strips *Pic*
Mrkim -- 10/9/2009, 1:53 pm
Re: Strip: Cutting Strips *Pic*
fred graus -- 10/9/2009, 3:06 pm
Re: Strip: Cutting Strips
Ed Darlington -- 10/10/2009, 5:46 am
Re: Strip: Cutting Strips
Mac McCaskie -- 10/17/2009, 5:42 pm
Re: Strip: Cutting Strips
Bill Hamm -- 10/11/2009, 12:31 am
Re: Strip: Cutting Strips
Mrkim -- 10/9/2009, 3:24 pm
Re: Strip: Cutting Strips
fred graus -- 10/9/2009, 3:44 pm
Re: Strip: Cutting Strips
Allan -- 10/9/2009, 9:56 pm
Re: Strip: Cutting Strips
Mrkim -- 10/9/2009, 4:17 pm
Re: Strip: Cutting Strips *LINK*
Ian Johnson -- 10/9/2009, 5:04 pm
Re: Strip: Cutting Strips *Pic*
Etienne Muller -- 10/9/2009, 6:26 am
Re: Strip: Cutting Strips
Mrkim -- 10/9/2009, 8:13 am
Re: Strip: Cutting Strips
Bill Hamm -- 10/10/2009, 1:33 am
Re: Strip: Cutting Strips
Brian Nystrom -- 10/9/2009, 8:18 pm
Re: Strip: Cutting Strips
Mac McCaskie -- 10/8/2009, 11:45 pm
Re: Strip: Cutting Strips
Bill Hamm -- 10/8/2009, 5:54 pm
Re: Strip: Cutting Strips
Terry Haines -- 10/11/2009, 12:56 am