Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: Strip: Form Building advice *Pic*
In Response To: Re: Strip: Form Building advice (etienne Muller)
: In the picture I have used MDF and shelving chipboard. I also use Plywood
: that I have lying around the place. If I know that I am not going to use
: forms for a particular boat again I use them again by cutting smaller
: forms for a new boat out of them. That is why there are multiple screw
: holes in some of the forms.
: Ply and chipboard definitely hold staples and pins better, but MDF is ok too.
: Et
Sorry here is the picture
: Et
Messages In This Thread
- Strip: Form Building advice
Benjamin F -- 10/13/2009, 4:22 pm- Re: Strip: Form Building advice
etienne Muller -- 10/16/2009, 9:04 am- Re: Strip: Form Building advice *Pic*
etienne Muller -- 10/16/2009, 9:05 am
- Re: Strip: Form Building advice
Malcolm Schweizer -- 10/14/2009, 2:45 pm- Re: Strip: Form Building advice
Fred -- 10/14/2009, 8:09 am- Re: Strip: Form Building advice
Bill Hamm -- 10/14/2009, 12:44 am- Re: Strip: Form Building advice
george jung -- 10/16/2009, 2:11 pm
- Re: Strip: Form Building advice
Allan -- 10/13/2009, 5:19 pm- Re: Strip: Form Building advice
Willn2Go -- 10/14/2009, 10:18 pm
- Re: Strip: Form Building advice *Pic*
- Re: Strip: Form Building advice
