Re: Strip: Strongback forms
In Response To: Re: Strip: Strongback forms (Bill Hamm)
: As long as the forms stay straight and flat, they will be fine. Can always
: add a small plywood filler over the cut to keep them flat.
: Bill H.
George
Yes it is a nice band saw. One of those things someone of greater skill usually has but I got it on a good barter...so, lucky me. I use it for the great precision cuts I can make with it. Only big bends are at the bow and stern where the forms are smaller and done with a scroll saw, where I use the drill as you suggest. Torque and breaking a form was my concern and didn't want a surprise when I started stripping.
Bill
Forms are of particle board and will stay flat.
Thanks
Kim
Messages In This Thread
- Strip: Strongback forms
Kim -- 11/1/2009, 2:03 pm- Re: Strip: Strongback forms
Bill Hamm -- 11/2/2009, 12:30 am- Re: Strip: Strongback forms
Kim -- 11/2/2009, 8:32 am
- Re: Strip: Strongback forms
george jung -- 11/1/2009, 8:27 pm - Re: Strip: Strongback forms
- Re: Strip: Strongback forms