Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: S&G: Free plan Guillemot... design(?) queery
By:Etienne Muller - Ireland
Date: 12/19/2009, 6:05 am

: When I am out
: surfing I tend to punch all but breaking waves at an angle ..
: that way the kayak doesn't launch itself into the air and slap
: down.

: By the way that will happen with any kayak.

: Go for it

: Cheers Pete

I do the same. Just a couple of points off the wind makes a big difference.

Upwind: the boat rides over waves rather than punching through them. In short choppy seas this causes a bit of slap on the descent, slowing the boat momentarily and causing splash in windy conditions. I have found that paddling a few degrees off the wind transforms the ride into a very pleasing rolling motion, and dry, with a marked increase in the sensation of speed.

For the full article:

http://etiennemuller.com/northstar/NSperformancereview.html

Messages In This Thread

S&G: Free plan Guillemot... design(?) queery
Brian Lemin -- 12/13/2009, 12:15 am
Re: S&G: Free plan Guillemot... design(?) queery
Pete Notman -- 12/18/2009, 7:32 pm
Re: S&G: Free plan Guillemot... design(?) queery
Etienne Muller - Ireland -- 12/19/2009, 6:05 am
Re: S&G: Free plan Guillemot... design(?) queery
Brian Lemin -- 1/2/2010, 11:00 pm
Re: S&G: Free plan Guillemot... design(?) queery
Mike -- 1/4/2010, 1:00 pm
Re: S&G: Free plan Guillemot... design(?) queery
Brian Lemin -- 1/4/2010, 7:14 pm
Re: S&G: Free plan Guillemot... design(?) queery
Bill Hamm -- 12/16/2009, 1:14 am
Re: S&G: Free plan Guillemot... design(?) queery
Brian Lemin -- 12/16/2009, 6:06 am
Re: S&G: Free plan Guillemot... design(?) queery
Ken Blanton -- 12/15/2009, 9:29 am
Re: S&G: Free plan Guillemot... design(?) queery
Don Goss -- 12/13/2009, 9:54 am
Re: S&G: Free plan Guillemot... design(?) queery
Mike Bielski -- 12/13/2009, 10:16 am
Re: S&G: Free plan Guillemot... design(?) queery
Brian Lemin -- 12/15/2009, 5:30 am
Re: S&G: Free plan Guillemot... design(?) queery
Allan -- 12/13/2009, 1:41 am