Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Transparent fiberglass
By:Jay Babina
Date: 12/22/2009, 10:53 am
In Response To: Strip: Transparent fiberglass *PIC* (mtkayak)

Sounds like a lot of your bases are covered. I put my plastic jugs of epoxiy into hot tap water buckets and that water is about 105 degrees. That temperature would lower the viscosity and perhaps help. You would have to experiment on a few scraps to see and that's the only thing you can do at this point.

Messages In This Thread

Strip: Transparent fiberglass *PIC*
mtkayak -- 12/22/2009, 10:04 am
Re: Strip: Transparent fiberglass
Bill Hamm -- 12/27/2009, 8:14 am
Re: Strip: Transparent fiberglass
Rob Macks / Laughing Loon CC&K -- 12/22/2009, 9:41 pm
Re: Strip: Transparent fiberglass *PIC*
mtkayak -- 12/23/2009, 6:03 pm
Re: Strip: Transparent fiberglass
Rob Macks / Laughing Loon CC&K -- 12/23/2009, 10:17 pm
Re: Strip: Transparent fiberglass
mtkayak -- 12/23/2009, 11:20 pm
Re: Strip: Transparent fiberglass
Chris Sperry -- 12/24/2009, 12:57 pm
Re: Strip: Transparent fiberglass
Rob Macks / Laughing Loon CC&K -- 12/25/2009, 9:22 am
Re: Strip: Transparent fiberglass
Chris Sperry -- 12/27/2009, 10:11 am
Re: Strip: Transparent fiberglass
Rob Macks / Laughing Loon CC&K -- 12/27/2009, 12:24 pm
Re: Strip: Transparent fiberglass
Bill Hamm -- 12/28/2009, 9:41 am
Re: Strip: Transparent fiberglass
Glen Smith -- 12/24/2009, 10:00 am
Re: Strip: Transparent fiberglass
Sam McFadden -- 12/22/2009, 1:09 pm
Re: Strip: Transparent fiberglass
john faas -- 12/22/2009, 2:22 pm
Re: Strip: Transparent fiberglass
Sam McFadden -- 12/22/2009, 3:02 pm
Re: Strip: Transparent fiberglass
Jay Babina -- 12/22/2009, 10:53 am
Re: Strip: Transparent fiberglass
johne -- 12/22/2009, 12:21 pm
Re: Strip: Transparent fiberglass
mtkayak -- 12/22/2009, 1:33 pm
Re: Strip: Transparent fiberglass
Mike Bielski -- 12/23/2009, 6:38 am
Re: Strip: Transparent fiberglass
Jay Babina -- 12/23/2009, 9:03 am
Re: Strip: Transparent fiberglass *PIC*
mtkayak -- 12/22/2009, 10:07 am
Re: Strip: Transparent fiberglass
Etienne Muller - Ireland -- 12/24/2009, 7:38 am