Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: S&G: art work on plywood *PIC*
In Response To: S&G: art work on plywood (John lasky)
Personally, I prefer inlay - metal or wood. For wood, cut out your design, trace it on the boat, route it out, glue it in, sand it down.
For metal, lay out the design on your hull, route it out, glue in your metal, sand it down. Epoxy and fiberglass over either method works, but is not necessary. Extreme care with the routing is!
Good luck!
Dave Gentry
A little foredeck inlay:
Messages In This Thread
- S&G: art work on plywood
John lasky -- 2/1/2010, 4:19 pm- Re: S&G: art work on plywood *PIC*
Doug S -- 2/2/2010, 8:02 am- Re: S&G: art work on plywood *PIC*
Charles Robinson -- 2/1/2010, 5:50 pm- Re: S&G: art work on plywood *PIC*
kiim -- 2/1/2010, 8:59 pm- Re: S&G: art work on plywood
Jon T -- 2/2/2010, 9:40 am
- Re: S&G: art work on plywood *PIC*
Kurt Maurer -- 2/1/2010, 6:43 pm- Dang, Here It Is Again *PIC*
Kurt Maurer -- 2/1/2010, 6:45 pm- Dear Uncle Nick,
Kurt Maurer -- 2/1/2010, 6:46 pm- Me, too! *NM*
Dave Gentry -- 2/1/2010, 11:26 pm
- Me, too! *NM*
- Dear Uncle Nick,
- Re: S&G: art work on plywood
- Re: S&G: art work on plywood
kiim -- 2/1/2010, 5:46 pm- Re: S&G: art work on plywood *PIC*
Dave Gentry -- 2/1/2010, 4:52 pm- Re: S&G: art work on plywood *PIC*
kiim -- 2/1/2010, 8:47 pm
- Re: S&G: art work on plywood *PIC*
- Re: S&G: art work on plywood *PIC*
