Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Strip: Inside hull sanding/ scraping
By:Joe Whitman
Date: 2/11/2010, 1:08 pm

Looking for some insite, I am in the glassing stage of my Great Auk Double. I am having a heck of a time sanding the inside curves of the hull. What is the best way to smooth in there? I have been hand sanding the curve since the ROS will not conform to it. Quarter the way done, and a loooooooong way to go. Thanks for any suggestions.

Messages In This Thread

Strip: Inside hull sanding/ scraping
Joe Whitman -- 2/11/2010, 1:08 pm
Re: Strip: Inside hull sanding/ scraping
Peter Sebbage -- 2/11/2010, 8:08 pm
Re: Strip: Inside hull sanding/ scraping
Joe Whitman -- 2/12/2010, 4:09 pm
Re: Strip: Inside hull sanding/ scraping
Ric -- 2/12/2010, 6:22 pm
Re: Strip: Inside hull sanding/ scraping
Bill Hamm -- 2/11/2010, 2:44 pm
Re: Strip: Inside hull sanding/ scraping
Fred -- 2/11/2010, 2:20 pm
Re: Strip: Inside hull sanding/ scraping
george jung -- 2/11/2010, 1:55 pm
Re: Strip: Inside hull sanding/ scraping
Joe Whitman -- 2/11/2010, 2:09 pm
Re: Strip: Inside hull sanding/ scraping
Jay Babina -- 2/11/2010, 4:14 pm